Pull the control cable taut and place clamp around control cable and hold against the rudder cable tunnel in the baggage compartment. Attach clamp with the spacer between the cable and the pocket using 2 MS35206-245 screws.ĥ. Drill 2 #18 (0.169) hole through clamp into map pocket. Move lever aft to just in front of the map pocket while holding clamp and verify that the cable operates smoothly.Ĥ. The control cable should be at its shortest length, and should be parallel to the rudder cable. Hold the clamp to the control cable and against the left map pocket. Push trim lever as far forward to just aft of the steel fuselage tube. If not previously installed, screw the trim cable into the MW3 rodend.ģ. The cable is Aircraft Spruce p/n 05-169144 A-950 push-pull cable 144 inches long.Ģ. With the belly skin removed from the tail cone, route the elevator trim cable through plastic snap bushings installed in each of the 3 bulkheads of the turtleback area.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |